Ld-systems MEI 1000 G2 User Manual download pdf (Page 10)

ENGLISHDEUTSCHFRANCAIS

FRANCAISFRANCAIS FRANCAISFRANCAIS

ESpAñoLpoLSKIITALIANo

SYSTEM SETUp:

TRANSMITTER PROGRAMMING:

MAIN MENU

In the main menu the radio frequency, the operating mode (mono/

stereo) and signal level (AF L and AF R) are displayed.

SELECTING A FREQUENCY GROUP 1 - 8

Press the SET button repeatedly until "GROUP SELECT" appears in the

display. Press the keys to select the desired frequency group.

SELECTING A CHANNEL 1 - 12

Press the SET button repeatedly until "CHANNEL SELECT" appears

in the display. Press the keys to select the desired channel.

Note: For simultaneous operation of several systems, please make

sure that all the systems use different channels on the same

frequency group.

SELECTING THE OPERATING MODE

Press the SET button repeatedly until "MODE SELECT" appears in

the display.

With the

buttons, you can now choose between mono and

stereo mode.

Select the mono mode if only one (mono)

audio signal is to be transmitted to the receiver. The signal is

located on two channels (left/right) of the receiver. In the mono

mode, only the right input (INPUT RIGHT) may be used.

Select the stereo mode if either a stereo signal, or two mono

signals are to be transmitted to the receiver.

Please refer to the notes in the Stereo and Focus Mode chapter.

LOCK AGAINST INADVERTENT CHANGES

Press the SET button repeatedly until "LOCK SELECT" appears in

the display. Press the keys to lock or unlock the system. If

"LOCK SELECT is enabled, the system settings can be viewed, but

not changed.

EXIT THE SETUP MENU

Press the SET button repeatedly until "EXIT SETUP" appears in the

display. Press the keys to exit the menu. If no control buttons are

pressed, the display switches automatically to the main menu after a

few seconds.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 133 134

No comments

Ld-systems MEI 1000 G2 User Manual Page 10